ReStory Chill Electronics Repairs How to Sell Guide

A ReStory Chill Electronics Repairs how to sell guide: the buy-repair-resell loop, whole unit versus parting out, and how to judge a listing before you pay.

Selling in ReStory runs on a simple loop: buy a cheap broken device from the in-game marketplace, restore it, and resell it for more than the purchase price plus parts. The decision that actually matters comes before you buy — whether a given listing is worth restoring at all, or is better used as a parts donor.

Three ways money comes in

Income arrives through three streams that trade off against each other rather than one being strictly better.

Income streamWhat it gives youThe catch
Customer ordersSteady payouts, reputation and story progressPace is set by who walks in
Online ordersConsistent work you can pull when the shop is quietThinner margins than a good flip
Marketplace resalesThe largest upside per deviceYou pay before you know what is broken

Customer orders are the backbone — they keep cash moving and are the stream tied to progression. Marketplace work is what you layer on top once a bad purchase will not stall a repair someone is waiting on.

Clear your fixed costs first

Rent runs about 2,000 per week, and internet is tiered at roughly 500, 1,000 and 1,500 per week. Both come out whether or not you complete a single job.

That makes a slow week negative rather than neutral. If your cash is near the line, take customer orders instead of gambling on a listing.

Work the numbers before you buy

Before committing to any purchase, run the calculation in this order:

  1. Estimate what the device sells for once fully restored.
  2. Subtract the asking price.
  3. Subtract the replacement parts you expect to need.
  4. Subtract anything else the job consumes.

What remains is your actual margin. If it is thin, the device is not a resale candidate — it is a parts donor, and valuing it that way is the correct outcome rather than a failure.

What makes a listing worth it

The traits that make a purchase work are fairly consistent:

  • A steep discount against the restored resale value
  • One clear fault rather than several unrelated ones
  • Several reusable components even if full restoration is uneconomic
  • A category you already hold the license for
  • A cleaning-heavy job rather than one needing expensive replacements

That last point matters because cleaning costs time rather than money. A filthy device with sound components is usually a better buy than a clean one with damaged ones.

Whole unit or parts?

Once a device is on your bench there are two exits, and the right one changes case by case. Selling the restored unit gives the higher headline figure, but only after you have paid for every replacement part.

Stripping it for components returns less, but those parts then feed paying customer orders where someone else covers the labour. The rule of thumb: if restoring would cost more in parts than the margin you calculated, stop and part it out. Money already spent on the purchase does not improve by spending more on top.

Condition affects the price

Cleanliness has been described as feeding into the price a restored device sells for, not just the star rating on a customer job. A half-cleaned unit is leaving money on the table twice over.

Since cleaning costs time rather than parts, it is usually the highest-return work you can do on a resale unit. See the cleanliness rating guide.

Don't replace what only needs cleaning

Every part reads as normal, dirty, or damaged. Dirty parts clean up and go back in; only damaged ones need replacing.

Misreading dirty as damaged destroys resale margins faster than anything else, because you are paying for components the job never required. Run the check on every part before ordering. The reassembly guide covers the workflow.

Keep some devices as stock

Not everything should be sold. Dismantling a donated or cheaply bought device turns it into a parts bin, and having the right component in stock is what lets you complete a paid customer order without waiting on a delivery.

Balancing "sell it" against "keep it as stock" is the main ongoing judgement call once your shop is stable.

Common ways people lose money

  • Buying a listing while rent is due and having to sell it off cheaply
  • Upgrading tools before licenses and stalling on locked categories
  • Fully restoring a device after the margin had already gone
  • Replacing parts that only needed cleaning

Keep a cash reserve for parts and customer orders, and move into higher-value resales only once weekly income comfortably clears rent and internet.


待确认: Specific device prices, resale values, part costs and margin figures are not established in the sources gathered and are deliberately not estimated here. The exact pricing formula — how condition, rarity and completeness combine — is also unconfirmed. Note that one previously-collected source for this topic was a shadow-wiki domain on the exclusion list and is not used.